
Growing Flax
Flax (Linum usitatissimum) is a cool-season annual grown either for its seed or for the long fibers in its stems, which are spun into linen. This guide covers fiber flax. It grows well here in Southwest Missouri (Zones 6b–7a) if you sow it early, because flax wants cool weather while it blooms and our summers turn hot fast. Just across the state line, southeast Kansas was once flax country.
At a glance
- Sun: full sun
- Water: about 1 inch a week until the plants start to ripen
- Soil pH: 6.0–7.0
- Sow: directly in the garden, late March to early April
- Depth: ¾–1 inch, with the soil firmed over the seed
- Density: 175–200 plants per square foot for fiber, several times thicker than flax grown for seed
- Harvest: pull the plants about 90–100 days after sowing, usually in early summer
- Rotation: don’t grow flax in the same spot two years running
Choosing seed
Fiber flax and seed flax are the same species, but the varieties differ: fiber types are bred for tall, straight stems with long fibers, while seed (oilseed) types are shorter and bred for seed. Look for seed sold specifically as fiber flax, from suppliers that specialize in heritage or fiber crops; few US sources carry it. Skip ornamental flax and the flaxseed sold for eating or oil.
When to plant
Around Springfield the average last spring frost is about April 10, and the first fall frost comes around October 22. Flax is a cool-season crop, so sow it before the last frost: the last week of March or the first week of April is traditionally the best time in this part of the country, and earlier is fine if the soil can be worked. Flax sown in May usually does worse, because it blooms in hot weather. For best growth it needs cool weather while it blooms and plenty of soil moisture until it starts to ripen.
Soil and site
Flax grows in almost any soil that would grow wheat or oats, as long as it drains well. Heavy clay that holds water is the exception; use a raised bed if yours stays wet. Prepare a fine, smooth surface over firm soil underneath.
Weeds are flax’s biggest problem. The plants are slender and open and don’t shade out weeds the way oats or wheat do, so start with a clean bed. Don’t grow flax where it grew the year before: flax wilt, a soil-borne disease, builds up and can last in the soil for several years. Rotate it on a 3–4 year cycle.
Planting
- Scatter the seed thickly and evenly over the prepared bed, aiming for 175–200 plants per square foot. A thick stand gives tall, straight, unbranched stems with the longest fiber.
- Rake the seed in ¾–1 inch deep, no deeper, and firm the soil over it so the seed is in good contact with it.
- Water gently if the soil is dry, and keep it moist until the seedlings are up.
Water, weeds and feeding
- Water about an inch a week. Moisture matters most early on, and the soil should stay moist until the plants start to ripen. Stop watering as they near harvest.
- Weed carefully for the first few weeks, until the flax is tall enough to crowd weeds out. In a stand this thick you’ll be pulling by hand rather than hoeing.
- Feed lightly, if at all. Flax doesn’t need much; on poor soil, a balanced fertilizer such as 10-10-10 at planting is enough.
Weeds and diseases
- Weeds: the main reason flax crops fail. A clean start and careful early weeding matter more than anything else you do.
- Flax wilt (Fusarium): plants wilt and die. It lives in the soil for years, so rotation is the only real defense.
Harvest
Fiber flax is pulled before the seed is ripe, about 90–100 days after sowing. It’s ready when the stems are turning yellow from the bottom up, the lower leaves have dropped, and the seed bolls are still green to yellowish. If you wait until the bolls are brown and the stems golden, which is when seed flax is cut, the fiber is coarser.
Pull the plants up by hand, roots and all, rather than cutting them. Pulling keeps the full length of the fiber. Keep the stems straight and lined up, roots together, as you go.
Retting and processing
- Ret the stems to loosen the fiber from the woody core. For dew retting, spread them in a thin layer on grass or a cleared bed and leave them to the dew and rain for 1–3 weeks. Check every few days: they’re ready when the fiber peels away from the core easily. Judging it takes practice, since under-retted stems are hard to clean and over-retted fiber is weak. Water retting, soaking the stems, takes a lot of water and leaves foul water behind, so dew retting is simpler for a small batch.
- Dry the retted stems thoroughly and store them somewhere dry until you’re ready to work them.
- Break the dry stems to crush the woody core, scutch them to scrape away the broken bits, and hackle them, combing the fiber through finer and finer teeth to clean it and line it up.
The cleaned fiber is then spun into linen thread.



